Help Center

Back to home

Help Center

Wavelet Devices

Wavelet Devices

Installation, sensor setup, maintenance, troubleshooting, pinouts, datasheets, Quick Start Guides and more for Wavelet devices.

Wavelet Firmware Upgrade

The threshold for the "External Power Source" data stream

Installation

Pre-Installation Check List

Connecting to the Device by Using AyyekaGo

Cellular Antenna Best Management Practices

Connecting to an External Power Source

Getting Started with an Ultrasonic CSO-SSO Sensor

Installing Ultrasonic and Radar Level Sensors to Measure Water Level

Installing KEP SUPERtrol Flow Computer Sensor

See more

Set up Sensors

Connecting a 4-20mA Sensor to a Wavelet

Configuring SDI-12 Sensors

Maintenance

Replacing Wavelet's Cover Gasket to the Updated 2022 Design

Device Maintenance - Monthly and On-going

Protecting Equipment from Lightning Strikes

Replacing the Battery

Replacing the Desiccants

Replacing Wavelet SIM Card

Replacing Wavelet 3 SIM Card

See more

Troubleshooting

How to Put Your Wavelet Into Hibernation Mode and how to take it out

Device Problems

Sensor Problems

Communication Problems

Transmission Problems

LED Light Status Indicators and Calibration Mode

Connecting to the Device by Using PuTTY

See more

General

Device Datasheets

Device Specifications

Device Quick Start Guides

Supported Accessories

Documentation for Supported and Deprecated Sensors

Connector 42-00009 Datasheet

Device Mechanical Drawings

Firmware

Using a LoRa-enhanced Wavelet

FAQ - Understanding LoRa Transmission

See more

Pinouts

Device Pinouts

Cable Splitter Pinouts

Cable Assembly Pinouts

External Power Supply Pinouts

Sensor Documentation

Configuring Ponsel (Aqualabo) Digisens Sensors

Enabling Temperature Compensation in an APG Ultrasonic Sensor

Advanced configuration

Using "always on" mode

Setting up scheduled data transmissions